It hasn't been rough riding beforehand apparently. Normally I turn the ignition key to the point where the dash lights come on, wait for most of them to go out, turn the key another notch, and the engine fires almost instantly. ... it would not even turn over it was dead.
best fix is to get the old connector cut off and put a new one on but pack it full of grease .
Can someone help with what could be the problem ... Search Renault Megane questions.
in the list of values start is allowed by the transponder so the key works (the red indicator remains fixed).
Hi, i have a Renault Modus 2005, drove it to work today and it was fine, got back in it to go home and it wouldn't start :crazy: There was nothing, then i tried to start it again and all the lights on the dash came on, flashing all over the place and a funny clicking noise was coming from the engine. The stop/start button won't start car but it allows it to stop . I had an issue with the starter motor which was replaced last week and works fine. Hello, I have a problem with a renault modus ... the starter does not run, no active fault codes but many stored codes and can not delete it, component test impossible (function not available) renault clip. I tried changing fuse but it keeps blowing the 25 amp fuse .
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by …
best fix is to get the old connector cut off and put a new one on but pack it full of grease . Renault Clio starting problem - Not the battery any ideas? Renault Key cards. I have a B-reg Renault Clio 1.2 Authentique, 19k miles. . Starter turns over at normal speed but engine doesn’t fire and plug and engine warning lights come on.
Both are causing owners to have a Renault car key problem. You may be … The symptoms are: Car wouldn't start last week. Clio Engine Turns But Wont Fire. It ran for around 50 mins then cut out and won't start. Really smokey for about 15 mins then cleared up.
I checked power to the pump and its around 12v, cut open old diesel filter and to my horror have found a small amount of metalic dust/filings in the bottom. Motor Vehicle Maintenance & Repair Stack Exchange is a question and answer site for mechanics and DIY enthusiast owners of cars, trucks, and motorcycles.
won’t start until cooler Solution The sensor is located on the top of the bell housing.